Tips Re-rockspace-local wifi extender setup
For
larger areas where wireless transmission is required, re-rockspace-local
wifi extender acts as a repeater to boost the signal and prevents it from
deadzone area. Basically, re-rockspace-localwifi extender works at 2.4G band thereby providing full signal coverage
with transmission speed of 300 Mbps. Also, AC1200 wifi range extender is
available that works at dual band and boost your home network by increasing the
range and speed of wifi signal. To setup the connection with router, one has to
just press the WPS button and within few seconds the connection to extend the
signal will be established. Similarly, a reset button is provided on the device
by which the wifi extender can be restored to default settings. The reset
button has to be pressed until the indicator turns red.
Steps to Follow Re-Rockspace-local
wifi extender Configuration
To
configure and connecting the re-rockspace-local wifi extender to a device, one
must follow the rockspace wifi extender setup instructions provided on http
//re-rockspace-local For extending the wifi signal by wifi extender, we can
make use of WPS button or can also login to Web UI (using a smart phone) and
check the signal strength. Moreover for better wifi coverage and signal
strength, the antennas must be positioned accordingly. Once you login
successfully to web UI, you can check the status of connected router or devices
and wifi name. On this page, we can also modify the settings of wifi extender
and can setup new login name and password. To save and activate any of the
modified settings, we have to reboot the extender. But if we reset the
extender, then it will be set to the default settings and one has to setup all
the settings again in the extender.
How to setup using
Re-rockspace-local
Basically,
the wireless signal of any router can be strengthen or repeated to provide full
signal coverage in dead-zone areas and this is fulfilled by the Rockspacewireless range extender. The setup for this extender can only be done through
offline mode at
No comments:
Post a Comment