Re-Rockspae-local Router setup Tips and tricks

Re-Rock space-local WiFi extender setup

For larger areas where wireless transmission is required, re-rockspace-local wifi extender acts as a repeater to boost the signal and prevents it from dead zone area. Basically, re-rock-space-local wifi extender works at 2.4G band thereby providing full signal coverage with transmission speed of 300 Mbps. Also, AC1200 wifi range extender is available that works at dual band and boost your home network by increasing the range and speed of wifi signal. To setup the connection with router, one has to just press the WPS button and within few seconds the connection to extend the signal will be established. Similarly, a reset button is provided on the device by which the wifi extender can be restored to default settings. The reset button has to be pressed until the indicator turns red.

Steps to Follow Re-Rockspace-local wifi extender Configuration

To configure and connecting the re-rockspace-local wifi extender to a device, one must follow the rockspace wifi extender setup instructions provided on http //re-rockspace-local. For extending the wifi signal by wifi extender, we can make use of WPS button or can also login to Web UI (using a smart phone) and check the signal strength. Moreover for better wifi coverage and signal strength, the antennas must be positioned accordingly. Once you login successfully to web UI, you can check the status of connected router or devices and wifi name. On this page, we can also modify the settings of wifi extender and can setup new login name and password. To save and activate any of the modified settings, we have to reboot the extender. But if we reset the extender, then it will be set to the default settings and one has to setup all the settings again in the extender.

Read more....